🐕‍🦺 Mazda 3 Window Switch Not Working

Remove the screws, then the power window switch. To test it – You can use a test light and probe behind the connector. Turn on the vehicle and activate the switch - check if you are getting continuity. If you are then the switch is bad. The rear window switch on the door from the dealer is about $7. just disconnect the battery for a few seconds, then try it. to reset the auto up/down you need to roll then window down and hold the switch for a few sec. then up and hold for a few sec. yeah i ended up unhooking the battery as it was pouring and i was running out of options. It was the safety feature as mentioned, really annoying though. Reset Procedure 2. If the above reset instructions do not work for your CX-3, then this alternate method may work. Start your CX-3. Close all windows and doors. Open the window by pressing and holding the window control switch. When the window is fully open, keep the switch pressed for a few seconds. When the window switch is activated to the UP position, voltage is applied to the motor up circuit and the motor down circuit serves as the path to ground. Ground for the left rear power window switch is supplied at G200 and the right rear power window switch receives ground at G201. The power locks work the same . Procedure. Unlock the vehicle and go to the driver’s seat. Locate the window switch on the vehicle’s door panel. Pop the window switch out on the bottom using a pick tool or a screwdriver and pull it back to remove it from the door panel. Disconnect the electrical connectors of the window switch by pushing the clip and pulling the connector The other three door locks work fine when it is not hot. However, when it is hot (104 F) like it was today the locks do not respond to any of the switches (driver, front passenger). Also, today the front passenger window would not work with either the driver switch or the door switch. Whether cooled down and the window started to respond. 58 posts · Joined 2011. #1 · Jan 6, 2012. Hey guys, I'm having a problem with my power window switch on the driver's door. The switch only works for the driver's window. The other windows work with their own switch at each of the windows. The switch did control both front windows but not anymore. Also the switch would do the 1" down function Hi, you will have to remove the door trim do check if the window motor is getting power from the switch to pin point what is wrong. The vehicle should still have new car warranty on it being a 2010 model so Id would suggest you take it back to a Mazda dealer to fix.They will use any excuse not to fix it under warranty if they see someone has tampered with it. Make sure that the power window lock switch located on the driver's door is not depressed. Press the switch and fully open the window. Pull up the switch to fully close the window and continue holding the switch for about 2 seconds after the window fully closed. Make sure that the power windows operate correctly using the door switches. Hello. New to the forums. I have been searching for about an hour now for info on this topic & I am stuck. If this has already been addressed I apologize. I drive a 2010 Mazda CX-9 Grand Touring. This morning I rolled my driver side window down to enter a code on a gate box. I thought I heard Note that, for the window to go up/down, +12V must be applied to one side of the motor, but also GND must be applied to the other side of the motor. You should check for continuity to ground in addition to checking for +12V. Also note that all of the current to raise/lower the windows passes through the switch itself. The 4x-switch is quite expensive, 260EUR =( So, I make some new connection. The faulty electronic is only for front windows, so now I connect wires so that I can use front windows with read window switch. (Rear windows is still working by those 2xback window switch) which is located between seats. Here is the conncection, at one's own risk. aPXibRy.

mazda 3 window switch not working